Kia Sportage: Accelerator Position Sensor (APS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Accelerator Position Sensor (APS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS): Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal
Refer to "Accelerator Pedal" in this group.
Installation
Refer to "Accelerator Pedal" in this group.
Accelerator Position Sensor (APS): Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS): Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system. It is installed on the fuel tank near the fuel pump assembly. It checks the evaporative s ...

Other Information:

Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for the first 1,000 km (600 miles) you may add to the performance, economy and life of your vehicle. Do not race the ...

Repair procedures
Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. 3. Run the engine at idle, then put a finger ove ...

Categories

Copyright www.kispmanual.com 2014-2026