Kia Sportage: Fuel Pressure Control Valve: Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Fuel Pressure Control Valve: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve: Repair procedures

Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal
Refer to "High Pressure Fuel Pump" in this group.
Installation
Refer to "High Pressure Fuel Pump" in this group.
Fuel Pressure Control Valve: Schematic Diagrams
Circuit Diagram ...

Electric Waste Gate Actuator (EWGA): Description and Operation
Desrcription The Electric WGT Control Actuator is installed on the turbocharger. It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount by the ECM''s P ...

Other Information:

Components and Components Location
Components 1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral & Longitudinal G sensor5. Steering angle sensor6. ABS Warning lamp7. Parking brake/EBD ...

Front Wheel Speed Sensor: Repair procedures
Removal 1. Remove the front wheel speed sensor mounting bolt (A). Tightening torque: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) 2. Remove the front wheel guard . 3. Disconnect ...

Categories

Copyright www.kispmanual.com 2014-2026