Kia Sportage: Underdrive Brake Control Solenoid Valve(UD/B_VFS): Repair procedures| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Remove the air duct (A).
|
| 3. |
Remove the air cleaner assembly.
|
| 4. |
Disconnect the solenoid valve connector (A).
|
| 5. |
Measure resistance between sensor signal terminal and ground terminal. |
| 6. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to "Valve Body" in Hydraulic System of this group) |
Underdrive Brake Control Solenoid Valve(UD/B_VFS): Schematic Diagrams
Overdrive Clutch Control Solenoid Valve(OD/C_VFS): Description and OperationCluster ionizer: Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to ...
Rear Wheel Speed Sensor: Repair procedures
Removal
1.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
2.
Remove the luggage side trim the disconnect the r ...