Kia Optima Manuals

Kia Sportage: Front Impact Sensor (FIS): Repair procedures - SRSCM - Restraint - Kia Sportage SL Service & Repair ManualKia Sportage: Front Impact Sensor (FIS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / SRSCM / Front Impact Sensor (FIS): Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A) and air cleaner assembly (B). (Driver front impact sensor only)

3.
Disconnect the front impact sensor connector (A).

4.
Remove the front impact sensor mounting bolt (B).
5.
Remove the front impact sensor.
Installation
   
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque :
7.0 ~ 9.0 Nm (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.6 lb.ft)
3.
Connect the front impact sensor connector.
4.
Install the air duct and air cleaner assembly. (Driver front impact sensor only)
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS): Components and Components Location
Components ...

Side Impact Sensor (SIS): Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar n ...

Other Information:

Removable towing hook
Front Rear 1.Open the tailgate, and remove the towing hook from the tool case. 2.Remove the hole cover pressing the lower part of the cover on the bumper. 3.Install the towing hook by turning ...

Headlight welcome function
When the headlight switch is in the ON or AUTO position and all doors (and tailgate) are closed and locked, if you press the door unlock button on the transmitter (or smart key), the headlights wi ...

Categories

Copyright www.kispmanual.com 2014-2026