Kia Optima Manuals

Kia Sportage: Side Airbag (SAB) Module: Repair procedures - Airbag Module - Restraint - Kia Sportage SL Service & Repair ManualKia Sportage: Side Airbag (SAB) Module: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Restraint / Airbag Module / Side Airbag (SAB) Module: Repair procedures

Removal
   
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the front seat assembly. (Refer to the Body group- Seat)
3.
Remove the seat back assembly. (Refer to the Body group- Seat)
Installation
   
Be sure to install the harness wires not to be pinched or interfered with other parts.
   
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the new seat back assembly.
(Refer to the Body group - Seat)
4.
Install the front seat assembly.
(Refer to the Body group - Seat)
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Side Airbag (SAB) Module: Components and Components Location
Components ...

Curtain Airbag (CAB) Module: Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain ai ...

Other Information:

Front Stabilizer Bar: Repair procedures
Replacement 1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub ...

Components and Components Location
Components Location 1. Fuel tank2. Fuel pump3. Fuel filter4. Fuel pressure regulator5. Canister6. Fuel tank air filter7. Fuel tank band 8. Fuel tank pressure sensor (FTPS) 9. Canister close ...

Categories


Copyright © www.kispmanual.com 2014-2025