Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the floor console upper cover. |
3. |
Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). |
4. |
Remove the mounting bolts (B).
|
5. |
Installation is the reverse of removal. |
Power Seat Control Switch: Repair procedures
Inspection
1.
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
Remo ...
Seat Belt Pretensioner (BPT): Components and Components Location
Components
...