If the remaining tread (A) depth is less than the limit, replace the tire.
When the tread depth of the tires is less than 1.6 mm(0.063 in.), the wear indicators (B) will appear.
Tire Rotation
Rotate the tires in the pattern illustrated.
Checking For Pull and Wander
If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure.
1.
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability.
2.
If the steering pulls to the opposite side, check vehicle''s
wheel alignment specitication first before fotationg the tires according
to the following wheel rotation procedure.
3.
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test.
4.
If the steering continues to pull to the opposite side, replace the front wheels with new ones.
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
When using an impact gun, fi ...
Other Information:
ACC(Accessory)
Orange indicator
• With automatic transaxle
Press the ENGINE START/STOP button while it is in the OFF position without depressing
the brake pedal.
If the ENGINE START/STOP button is in the ACC ...
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the igni ...