Kia Sportage: Windscreen defrosting and defogging![]() |
![]() |
Operation
Set the fan speed to the level you need.
Choose the desired temperature.
Select the appropriate defrosting or defogging mode:
or
.
The system automatically selects outside (fresh) air and switches on the air conditioning.
WARNING
Windscreen heating
In extremely humid weather, do not use the
or
mode while cooling the cabin. The difference between
the outside air and windscreen temperatures may cause condensation to form on the outer glass surface and reduce
visibility. If this happens, select the
mode and set the fan to a lower speed.
![]() |
Operation
When the Auto Defogging System activates, it automatically adjusts the climate controls to clear moisture from the windscreen:
The air conditioning switches on at a low temperature.
The airflow mode changes to direct air towards the windscreen.
The fan speed increases.
Operating conditions
The heater or air conditioning system is operating.
The system detects a high level of humidity inside the vehicle.
Operation
With the climate control system on, select the button shown here
, then press the air intake button five times within 3
seconds.
If the function is cancelled, the
button
indicator flashes three times.
If the function is reset, the
button indicator
flashes six times.
NOTE
When Auto Defogging switches on the air conditioning, you cannot turn the air conditioning off while the system is operating.
For the system to work effectively, do not select recirculated air while Auto Defogging is active.
While Auto Defogging is operating, the fan speed control, temperature control and air intake control are disabled.
Do not remove the sensor cover at the upper edge of the driver-side windscreen.
Removing it may damage system components, and the damage may not be covered by the vehicle warranty.
![]() |
Operation
Press the rear window defroster button. Its indicator illuminates while the defroster is on.
The defroster switches off after approximately 20 minutes or when the vehicle is switched off.
CAUTION
Rear window conductors
The heating conductors are bonded to the inside of the rear window. To avoid damaging them, do not clean the glass with sharp tools or abrasive window cleaners.
![]() |
Operation
Switch the vehicle to ON.
Select
.
Within 10 seconds, press the air intake button five times while pressing the air conditioning (A/C) button.
The indicator flashes three times to confirm the reset.
Reset the defogging logic if the battery has been disconnected or discharged.
Curtain Airbag (CAB) Module: Repair procedures
Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the roof trim. (Refer to the Body group- Interior)
3.
Disconnect the ...
Air conditioning
Kia Air Conditioning Systems are filled with environmentally friendly R-134a
refrigerant.
1.Start the engine. Press the air conditioning button.
2.Set the mode to the position.
3.Set the air int ...
Exhaust Manifold: Repair procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening torque
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
3.
Disconnect t ...