Kia Optima Manuals

Kia Sportage: Antenna: Repair procedures - Audio - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Antenna: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Audio / Antenna: Repair procedures

Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable.

3.
Check for continuity between the outer poles of antenna cable. There should be continuity.

4.
If there is no continuity, replace the antenna cable.
5.
Check for continuity between the center pole (A) and outer pole (B) of antenna cable. There should be no continuity.

6.
If there is continuity, replace the antenna cable.
Removal
Roof Antenna
1.
Remove the rear roof trim.
(Refer to the BD group - "Roof trim")
2.
Disconnect the roof antenna feeder cable and connector (A) from the roof antenna.

3.
Disconnect the antenna power cable (A).

4.
Remove the roof antenna (A) after removing a nut.

Installation
1.
Install the roof antenna to the roof panel.
Tightening torque(nut) :
8 ~ 15 Nm (0.8 ~ 1.5 kgf.m , 5.8 ~ 10.8 lb-ft)
2.
Connect the feeder cable to the antenna.
3.
Connect the power cable to the antenna.
4.
Install the rear roof trim.
   
–
Make sure that the cables and connectors are plugged in properly.
–
Check the audio system.
Speakers: Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector ...

Audio Remote Control: Components and Components Location
Component Location 1. Audio remote control switch (Left)2. Audio remote control switch (Right)3. Bluetooth switch4. Voice switch5. Audio remote control switch6. Cruise remote control switch ...

Other Information:

Power Mosfet: Repair procedures
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification ...

If the engine will not start
If engine doesn't turn over or turns over slowly 1.If your car has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2.Check the bat ...

Categories

Copyright www.kispmanual.com 2014-2026