Kia Sportage: If the engine will not start - What to do in an emergency - Kia Sportage SL Owners ManualKia Sportage: If the engine will not start

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / What to do in an emergency / If the engine will not start

If engine doesn't turn over or turns over slowly

1.If your car has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2.Check the battery connections to be sure they are clean and tight.

3.Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4.Check the starter connections to be sure they are securely tightened.

5.Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING - Push/pull start

Do not push or pull the vehicle to start it. Push or pull starting may cause the catalytic converter to overload and create a fire hazard.

If engine turns over normally but does not start

1.Check the fuel level.

2.With the ignition switch in the LOCK position, check all connectors at the ignition coils and spark plugs. Reconnect any that may be disconnected or loose.

3.Check the fuel line in the engine compartment.

4.If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.

In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you h ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...

Other Information:

To increase cruise control set speed
Follow either of these procedures: Push the RES + switch and hold it. Your vehicle will accelerate. Release the switch at the speed you want. Push the RES + switch and release it immediatel ...

35R Clutch Control Solenoid Valve(35R/C_VFS): Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). 3. Remove the air cleaner assembly. (1) Disconnect the breather hose (A) and brake booster intensifier hose. (2) ...

Categories


Copyright © www.kispmanual.com 2014-2024