Kia Sportage: Care of seat belts - Seat belts - Safety features of your vehicle - Kia Sportage SL Owners ManualKia Sportage: Care of seat belts

Third generation SL (2010–2016) / Kia Sportage SL Owners Manual / Safety features of your vehicle / Seat belts / Care of seat belts

Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse.

WARNING - Pinched Seat belts

Make sure that the webbing and/or buckle does not get caught or pinched in the rear seat when returning the rear seatback to its upright position. A caught or pinched webbing/buckle may become damaged and could fail during a collision or sudden stop.

Periodic inspection

All seat belts should be inspected periodically for wear or damage of any kind. Any damaged parts should be replaced as soon as possible.

Keep belts clean and dry

Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned by using a mild soap solution and warm water. Bleach, dye, strong detergents or abrasives should not be used because they may damage and weaken the fabric.

When to replace seat belts

The entire in-use seat belt assembly or assemblies should be replaced if the vehicle has been involved in an accident. This should be done even if no damage is visible. Additional questions concerning seat belt operation should be directed to an authorized Kia dealer.

Do not lie down
To reduce the chance of injuries in the event of an accident and to achieve maximum effectiveness of the restraint system, all passengers should be sitting up and the front and rear seats should b ...

Child restraint system
Children riding in the car should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accident s ...

Other Information:

Oil Seal: Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) (Refer to "Front Driveshaft" in Driveshaft and axle) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). ...

Room lamp
The light will turn on and off as follw if the switch is moved. • ON : The light stays on at all times. • OFF : The light stays off at all times. • DOOR : The light comes on when any door is open ...

Categories


Copyright © www.kispmanual.com 2014-2024