Kia Sportage: Front Fog Lamps: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Front Fog Lamps: Repair procedures

Inspection

Front Fog Lamp Switch

1.	With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper. (Refer to the BD group - "Front bumper")

3.	Remove the front fog lamp (A) by turning in the counterclockwise direction after disconnecting the connector.

4.	Remove the front fog lamp (B) after loosening the screws.

Installation

1.	Install the front fog lamp bulb.

2.	Connect the front fog lamp connector.

3.	Install the front bumper.

Rheostat: Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the crash pad side switch assembly (A) af ...

License Lamps: Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the lens (A) and license lamp (B) after loosening 2 screws. Installation 1. Install the bulb. 2. Install the license ...

Other Information:

RCV Control Solenoid Valve: Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV control solenoid valve connector. 3. Measure resistance between the valve terminals 1 and 2. 4. Check that the resista ...

ESC (Electronic Stability Control) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions and under normal ...

Kia Sportage: Front Fog Lamps: Repair procedures

Rheostat: Repair procedures

License Lamps: Repair procedures

Other Information:

Categories