Kia Optima Manuals

Kia Sportage: Console: Repair procedures - Interior - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Console: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Interior / Console: Repair procedures

Replacement
Floor Console Replacement
[M/T]
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the gear boots (A).

2.
Using a screwdriver or remover, remove the console upper cover (A).

3.
After loosening the mounting screws, then remove the floor console tray (A).

4.
Disconnect the connector (A).

5.
Remove the console side cover (A).

6.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).

7.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
[A/T]
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the gear boots (B) and gear knob (A).

2.
Using a screwdriver or remover, remove the console upper cover (A).

3.
Disconnect the connector (A).

4.
After loosening the mounting screws, then remove the floor console tray (A).

5.
Disconnect the connector (A).

6.
Remove the console side cover (A).

7.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).

8.
Disconnect the floor console main connector (A).

9.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damage clips.
Armrest Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the rear console cover (A).

2.
After loosening the mounting screws, then remove the armrest cover (A).

3.
After loosening the mounting screws, then remove the armrest assembly (A).

4.
Installation is the reverse of removal.
   
•
Replace any damage clips.
Console: Components and Components Location
Components [ M/T] 1. Floor console assembly2. Floor console tray3. Console upper cover [5 speed M/T]4. Console upper cover [6 speed M/T]5. Console storage box mat6. Console side cover [LH]7. C ...

Crash Pad: Components and Components Location
Components 1. Main crash pad assembly2. Crash pad side cover [LH]3. Crash pad side cover [RH]4. Cluster fascia panel5. Reinforcing panel6. Crash pad lower panel7. Center facia panel8. Crash pad g ...

Other Information:

Repair procedures
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3. If continu ...

Snow tires
If you mount snow tires on your vehicle, make sure they are radial tires of the same size and load range as the original tires. Mount snow tires on all four wheels to balance your vehicle’s hand ...

Categories

Copyright www.kispmanual.com 2014-2026