Removal |
1. |
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. |
2. |
Remove the roof trim. (Refer to the Body group- Interior) |
3. |
Disconnect the curtain airbag harness connector (A). |
4. |
After loosening the mounting bolts and nuts remove the curtain airbag. |
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable and wait for at least thirty seconds. |
3. |
Tighten the curtain airbag mounting bolts.
|
4. |
Connect the curtain airbag connector. |
5. |
Install the roof trim. (Refer to the Body group- Interior) |
6. |
Reconnect the battery negative cable. |
7. |
After installing the curtain airbag (CAB), confirm proper system operation:
|
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your
sunroof system as follows:
1.Turn the ignition switch to the ON position.
2.Open the roller blind.
3.Close the sunr ...
4WD system warning light
When the ignition switch is turned to the ON position, the 4WD indicator will
illuminate and then go off in a few seconds.
If the 4WD system warning light illuminates, this indicates that there i ...