Kia Optima Manuals

Kia Sportage: Front Bumper: Repair procedures - Bumper - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Front Bumper: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Bumper / Front Bumper: Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
•
Take care not bend or scratch the cover and other parts.
1.
Loosen the radiator upper cover (A) mounting clips and bolts.

2.
Remove the under cover (A) mounting clips.

3.
After loosening the front bumper side’s mounting screw, then disconnect the side’s.
   
•
When you pull out the front bumper, the front bumper could be damaged by the projection (A).

4.
Disconnect the fog lamp (A), turn signal lamp (B), front sensor (C).
5.
Remove the front bumper.
[LH]

[RH]

6.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damage clips.
Front Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [LH]3. Front bumper side bracket [RH] ...

Rear Bumper: Components and Components Location
Components 1. Front bumper cover2. Front bumper side bracket [RH]3. Front bumper side bracket [LH] ...

Other Information:

Evaporator Temperature Sensor: Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Spe ...

3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls exhaust emissions while maintaining good vehicle performance. Vehicle modifications This vehicle should not be modif ...

Categories

Copyright www.kispmanual.com 2014-2026