Kia Optima Manuals

Kia Sportage: Fuel Tank Pressure Sensor (FTPS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Fuel Tank Pressure Sensor (FTPS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS): Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD group).
3.
Remove the fuel pump service cover (A).

4.
Disconnect the fuel tank pressure sensor connector (A).
5.
Remove the fuel tank pressure sensor after releasing the hooks vertically.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Fuel Tank Pressure Sensor (FTPS): Schematic Diagrams
Circuit Diagram ...

Injector: Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is cont ...

Other Information:

General Information
General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight c ...

Rear Body: Body Repair
Side outer panel rear cornerTail gate hinge mounting hole (O12)Tail gate lifter mounting hole (O9)Side outer panel rear cornerRear bumper mounting hole (8.5X8.5)Rear bumper mounting hole (14X16)Re ...

Categories

Copyright www.kispmanual.com 2014-2026