Kia Sportage: Hazard Lamp Switch: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Hazard Lamp Switch: Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the center fascia panel (A).
(Refer to BE group - "Audio unit")
|
| 3. |
Disconnect the hazard switch unit connector (A).
|
| 4. |
If the hazard lamp switch is not as specified, replace it carefully and take care not to damage the hook (A).
|
| Installation |
| 1. |
Connect the hazard switch connector. |
| 2. |
Install the hazard switch assembly to the center fascia panel. |
| Inspection |
| 1. |
Operate the switch and check for continuity between terminals with an ohmmeter.
|
Overhead Console Lamp: Repair procedures
Inspection
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
No.DescriptionNo.Descrip ...
Rheostat: Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Remove the crash pad side switch assembly (A) af ...
Other Information:
Rear seat heater
The seat heater is provided to warm the rear seats during cold weather. With
the ignition switch in the ON position, push either of the switches to warm rear
seats.
During mild weather or under ...
Front Driveshaft: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.3 ~ ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026