Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
No.
Description
No.
Description
1
Ground
4
Door (-)
2
-
5
Battery (+)
3
-
6
-
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly.
(Refer to the BD group - "Roof trim")
3.
Remove the overhead console bulb (B) after disconnecting the panoramaroof switch connector and lamp connector (A).
4.
When replacing the bulb only, release the lens (C) cover from the roof without removing the overhead console lamp assembly.
Inspection
1.
Remove the room lamp assembly connector then check for continuity between terminals.
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) fro ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to BE group - "Audio unit")
Take care not to damage and sc ...
Ventilation
1.Set the mode to the position.
2.Set the air intake control to the outside (fresh) air position.
3.Set the temperature control to the desired position.
4.Set the fan speed control to the desired ...