Kia Optima Manuals

Kia Sportage: Input Speed Sensor: Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sportage SL Service & Repair ManualKia Sportage: Input Speed Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor: Repair procedures

Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(Refer to "Valve Body" in Hydraulic System of this group)
2.
Disconnect the input & output speed sensor connector (A) from the main wiring.
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Install in the reverse order of removal.
   
•
Adding Automatic Transaxle Fluid (ATF).
(Refer to "Fluid" in Hydraulic System of this group)
•
Use new valve body gasket (A).

Input Speed Sensor: Troubleshooting
Signal Waveform Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Output Speed Sensor: Description and Operation
Description The Output Speed Sensor is a vital unit that measures the rate of rotation of the transmission''s turbine shaft and output shaft, and delivers the readings to the TCM. ...

Other Information:

Turbo Charger: Components and Components Location
Components 1. Turbine housing2. Turbine inlet3. Turbine outlet4. Compressor housing5. Compressor inlet6. Compressor outlet7. Center housing8. EWGA (Electric Waste Gate Actuator)9. Actuator rod ...

Description and Operation
Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, int ...

Categories

Copyright www.kispmanual.com 2014-2026