Kia Sportage: Output Speed Sensor: Description and Operation
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor: Description and Operation
| Description |
The Output Speed Sensor is a vital unit that measures the
rate of rotation of the transmission''s turbine shaft and output shaft,
and delivers the readings to the TCM.
The sensor provides critical input data that''s used in
feedback control, damper clutch control, gear setting control, line
pressure control, clutch activation pressure control, and sensor fault
analysis.
Input Speed Sensor: Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the valve body assembly.
(R ...
Output Speed Sensor: Specifications
Specifications
? Type: Hall effect sensor
Operation condition (°C)°F(-40~150) -40~302Air gap (mm)in.(0.25~0.70) 0.0098~0.0276Output voltage (V)High1.18 ~ 1.68Low0.59 ~ 0.84
...
Other Information:
Smart key: Repair procedures
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.
2.
Select the vehicle model a ...
SRS Control Module (SRSCM): Repair procedures
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Disconnect the DAB, PAB, SAB, CA ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2025