Kia Optima Manuals

Kia Sportage: Mirror: Repair procedures - Exterior - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Mirror: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Exterior / Mirror: Repair procedures

Replacement
Outside Rear View Mirror Assembly Replacement
   
Do not disassemble the mirror when painting the mirror housing. Paint the mirror housing after masking the parts which do not need to be painted.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Remove the front door quadrant inner cover (A).

2.
Disconnect the connector (A).
3.
After loosening the mounting bolts, then remove the outside rear view mirror (B).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Installation is the reverse of removal.
Inside Rear view Mirror Replacement
1.
Push the inside rear view mirror base (A) down to remove to inside rear view mirror assembly (B).

2.
Installation is the reverse of removal.
ECM Mirror Replacement
1.
Remove the ECM mirror cover (A).

2.
Disconnect the ECM mirror connector (B).
3.
Loosen the mounting screw (C), push the ECM mirror base up to remove the ECM mirror assembly (A).

4.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
Panoramaroof: Repair procedures
Replacement Movable Glass Replacement 1. Remove the roof rack and roof moulding. (Refer to the BD group - "Body Side Mouldings") 2. Open the movable glass. 3. Loosen the movable glass (A ...

Cowl Top Cover: Repair procedures
Replacement 1. Remove the wiper arm cover (B). 2. After loosening the mounting nuts, then remove the wiper arm (A). Tightening torque : 22.6 ~ 26.5 N.m (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft ...

Other Information:

Seat belt warning
As a reminder to the driver, the seat belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON, regardless of belt fastening. If the driver's seat b ...

Side Impact Sensor (SIS): Components and Components Location
Components ...

Categories


Copyright © www.kispmanual.com 2014-2025