Kia Sportage: Navigation-based Smart Cruise Control operation - Navigation-based Smart Cruise Control (NSCC): (if equipped) - Driver assistance systemKia Sportage: Navigation-based Smart Cruise Control operation

Kia Sportage Owner’s Manual (5th Generation, NQ5; 2022+) / Driver assistance system / Navigation-based Smart Cruise Control (NSCC): (if equipped) / Navigation-based Smart Cruise Control operation

Operating conditions

Navigation-based Smart Cruise Control is ready to operate only when all of the following conditions are met:

NOTE

For instructions on using Smart Cruise Control, see the Smart Cruise Control (SCC) section.

Navigation-based Smart Cruise Control display and control

Kia Sportage instrument cluster display for Navigation-based Smart Cruise Control

When Navigation-based Smart Cruise Control is active or ready, its status is shown on the Kia Sportage instrument cluster as described below.

Standby

When all operating conditions are met, the green indicator Green Navigation-based Smart Cruise Control standby indicator on the Kia Sportage cluster appears to show that the system is ready.

Operating

While the system is controlling the vehicle’s speed, the green indicator Green Navigation-based Smart Cruise Control active indicator on the Kia Sportage cluster is illuminated.

Pause/driver operation

If Smart Cruise Control is paused or navigation rerouting prevents it from operating, the grey indicator Grey Navigation-based Smart Cruise Control paused indicator on the Kia Sportage cluster appears on the instrument cluster.

If the driver presses the accelerator pedal, the white indicator White Navigation-based Smart Cruise Control driver-operation indicator on the Kia Sportage cluster flashes on the cluster.

WARNING

The following warning appears if Navigation-based Smart Cruise Control cannot reduce the vehicle’s speed to a safe level:

Kia Sportage instrument cluster warning instructing the driver to drive carefully

A: Drive carefully

NOTE

Instrument cluster images and colours may vary with the cluster type or the theme selected in the settings menu.

Highway Curve Zone Auto Slowdown

When the Kia Sportage approaches a mapped curve on a highway or motorway, the system can reduce speed for the bend. After the vehicle passes the curve, it accelerates back to the Smart Cruise Control set speed.

NOTE

The point at which deceleration begins depends on the vehicle’s speed and the curve’s sharpness. At higher speeds, the system begins slowing down earlier.

Navigation-based Smart Cruise Control settings. Auto Highway Speed Change
Auto Highway Speed Change Driver Assistance Driving Convenience ...
Navigation-based Smart Cruise Control limitations
Navigation-based Smart Cruise Control may not operate as intended in the situations listed below. For example, because the system relies on navigation guidance, it may slow the Kia Sportage if the ...
See also:

Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1.6 mm (1/16 inch) of tread left on the tire. Replace the tire when ...

Injector: Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is fro ...

Schematic Diagrams
Circuit Diagram ...

Categories

Copyright © www.kispmanual.com 2014-2026 - 0.0593