Kia Sportage: Oil Pressure Switch: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch: Repair procedures
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch. |
| 3. |
If there is no continuity when a 50kPa (0.50kgf/cm?, 7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Oil Cooler: Repair procedures
Removal
1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant hoses (A).
3.
Remove the oil filter (A).
4.
Loo ...
Other Information:
Immobilizer indicator
With smart key system
If any of the following occurs in a vehicle equipped with the smart key, the
immobilizer indicator illuminates, blinks or goes off.
When the smart key is in the vehicle, ...
ESC (Electronic Stability Control) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but
should go off after approximately 3 seconds. When the ESC is on, it monitors the
driving conditions and under normal ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026