Replacement |
1. |
Remove the driveshaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
2. |
Remove the dust cover (A). |
3. |
Remove the oil seal (A, B). |
4. |
Install the oil seal with special service tools.
|
5. |
Install the new dust cover (A). |
6. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
7. |
Install the drive shaft assembly. (RH side)
(Refer to "Front Driveshaft" in Driveshaft and axle) |
1. |
Remove the transfer assembly from the transaxle assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
2. |
Remove the oil seal (A). |
3. |
Install the oil seal with special service tools (09473-3B100).
|
4. |
Add to transfer fluid.
(Refer to "Transfer Fluid" in Front Wheel Transfer Assembly of this group) |
5. |
Install the transfer assembly.
(Refer to "Front Wheel Transfer Assembly" in this group) |
Master Cylinder: Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the battery terminal and then remove the battery.
3.
Disconnect the ECM connector and the E ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS): Description and Operation
Description
Underdrive brake control solenoid valve(UD/B) is attached to
the valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the underdrive brake. ...