Kia Sportage: Rear Axle Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Rear Axle Assembly

Front Driveshaft: Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.3 ~ ...

Rear Hub - Carrier: Components and Components Location

Components 1. Hub cover2. Carrier assembly3. Hub & bearing assembly4. Hub mounting bolt5. Bushing6. Bushing7. Carrier assembly8. Bearing9. Snap ring10. Hub assembly11. Hub bolt12. Bushing ...

Other Information:

ESC (Electronic Stability Control) indicator
The ESC indicator will illuminate when the ignition switch is turned ON, but should go off after approximately 3 seconds. When the ESC is on, it monitors the driving conditions and under normal ...

Rear Washer Switch: Repair procedures
Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch. Rear Wiper Switch Rear Was ...