Kia Sportage: Rear Driveshaft Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Rear Driveshaft Assembly

Rear Hub - Carrier: Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.3 ~ 1 ...

Rear Driveshaft: Components and Components Location

Component location 1. Coupling2. Sub frame3. Assist arm4. Lower arm5. Upper arm6. Trailing arm7. Coil spring8. Shock absorber9. Stabilizer10. Drive shaft11. Differential carrier assembly Compone ...

Other Information:

Seat belt warning (for driver’s seat)
As a reminder to the driver, the seat belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON regardless of belt fastening. If the driver's seat be ...

TPMS Sensor: Description and Operation
Description 1. Mode (1) Normal Fixed Base State • Sensor transmissions continue at the Low Line (Base) configuration defined rates until the state is either changed by LF command o ...