Kia Sportage: Rear Wheel Speed Sensor: Repair procedures - ESC(Electronic Stability Control) System - Brake System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Wheel Speed Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor: Repair procedures

Removal
1.
Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.
Remove the luggage side trim the disconnect the rear wheel speed sensor connector.
3.
Installation is the reverse of removal.
Inspection
1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
   
In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resistor must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.


V_low : 0.59V ~ 0.84V
V_high : 1.18V ~ 1.68V
Frequency range : 1 ~ 2,500Hz

Rear Wheel Speed Sensor: Components and Components Location
Components 1. Rear wheel speed sensor connector2. Rear wheel speed sensor ...

Yaw-rate and Lateral G Sensor: Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor. ...

Other Information:

Ignition key interlock system
The ignition key cannot be removed unless the shift lever is in the P (Park) position. Even if the ignition switch is in the LOCK position, the key also cannot be removed. If your vehicle is equi ...

Electric power steering
Power steering uses the motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require ...

Categories

Copyright © www.kispmanual.com 2014-2026