As a reminder to the driver, the seat belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON, regardless of belt fastening.
If the driver's seat belt is not fastened when the ignition switch is turned on, the seat belt warning light and the seat belt warning chime will operate for approximately 6 seconds. But if it is fastened within the 6 seconds, the warning light will blink until the 6 seconds are up The warning chime will turn off immediately.
If the driver's seat belt is disconnected after the ignition switch is turned to the ON position, the seat belt warning light will blink for approximately 6 seconds. But if it is fastened within the 6 seconds the warning light will turn off immediately. If the driver's seat belt is not fastened when the vehicle speed exceeds 10 km/h (6 mph), the seat belt warning light and chime will operate approximately 11 times with a pattern of 6 seconds on and 24 seconds off until the belt is fastened or the vehicle speed decreases below 5 km/h (3 mph).
For front passenger’s seat belt warning light on the center facia, refer to ‘seat belt’ in section 3.
Description and Operation
Description
This function describes the following features
–
Input detection by Auto Light Sensor.
–
Generate Auto Light Out Status data.
–
Send Auto Light Out Status.
...
Passive Occupant Detection System (PODS): Description and Operation
Description
The system is intended to classify the occupancy status of
the front passenger seat in a motor vehicle based upon the measured
force on the bottom seat cushion.
The system also com ...