Kia Sportage: Shift Lever: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever: Repair procedures

Removal

1.	Remove the center console assembly. (Refer to "Interior(console)" in BD group.)

2.	Disconnect sports mode connector (A).

Remove the shift lever assembly (D).

(1)	Take off the clip (A) and then remove the shift cable (B).

(2)

Remove the bolts (C-4ea).

Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation

When installing, set room side shift lever and T/M side lever to "N" position.

1.	Install in the reverse order of removal.

Shift Lever: Components and Components Location

Components 1. Shift lever knob & boots assembly2. Shift lever assembly3. Shift cable assembly4. Cable retainer5. Shift cable retainer ...

Shift Cable: Components and Components Location

Components 1. Shift lever knob & boots assembly2. Shift lever assembly 3. Shift cable assembly4. Cable retainer ...

Other Information:

Weight of the trailer tongue
The tongue load of any trailer is an important weight to measure because it affects the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb weight of the vehicle, any ...

Engine compartment
GDI engine T-GDI engine 1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch* fluid reservoir 4. Positive battery terminal 5. Negative battery terminal 6. Fuse box 7. Air c ...

Kia Sportage: Shift Lever: Repair procedures

Shift Lever: Components and Components Location

Shift Cable: Components and Components Location

Other Information:

Categories