Inspection |
1. |
Disconnect the negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Disconnect the switch connector (16 pins) from wiring harness. |
4. |
Check for continuity between the terminals. If needed, replace the switch. |
Removal |
1. |
Disconnect the negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Remove the screws from power window switch (A) and connectors (B). |
4. |
Remove the driver power window switch (A) from front door trim.
|
Installation |
1. |
Install the power window switch and connectors. |
2. |
Install the front door trim. |
Engine oil pressure warning light
This warning light indicates the engine oil pressure is low.
If the warning light illuminates while driving:
1.Drive safely to the side of the road and stop.
2.With the engine off, check the engi ...
Balance Shaft & Oil Pump: Components and Components Location
Components
1. Balance shaft & oil pump assembly2. Balance shaft chain tensioner3. Balance shaft chain4. Balance shaft chain sprocket5. Balance shaft chain guide6. Balance shaft chain tensione ...