Inspection |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Disconnect the connector from the motor.
(A : Safety, B : Standard) |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Standard] |
5. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and check that the motor operates smoothly when connecting the
terminals below.
[Safety] |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Disconnect the connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
Injector: Troubleshooting
Signal Waveform
The three waveforms below are taken from the #1 and #4
injectors. The top waveform is from the high side (feed side) of the #1
and #4 injectors, while the middle waveform is fro ...
Key reminder warning chime
If the driver’s door is opened while the ignition key is left in the ignition
switch (ACC or LOCK position), the key reminder warning chime will sound. This is
to prevent you from locking your key ...