Kia Sportage: Overhead Console Lamp: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Overhead Console Lamp: Repair procedures

Inspection

Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

No.	Description	No.	Description
1	Ground	4	Door (-)
2	-	5	Battery (+)
3	-	6	-

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the overhead console lamp assembly. (Refer to the BD group - "Roof trim")

3.	Remove the overhead console bulb (B) after disconnecting the panoramaroof switch connector and lamp connector (A).

4.	When replacing the bulb only, release the lens (C) cover from the roof without removing the overhead console lamp assembly.

Installation

1.	Install the bulbs and connect the connectors.

2.	Install the overhead console lamp assembly.

Room Lamp: Repair procedures

Inspection 1. Remove the room lamp assembly connector then check for continuity between terminals. Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) fro ...

Hazard Lamp Switch: Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel (A). (Refer to BE group - "Audio unit") Take care not to damage and sc ...

Other Information:

Knock Sensor (KS): Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

To defrost outside windshield
1.Set the fan speed to the highest position. 2.Set the temperature to the extreme hot (HI) position. 3.Press the defroster button (). 4.The outside (fresh) air position will be selected automatic ...

Kia Sportage: Overhead Console Lamp: Repair procedures

Room Lamp: Repair procedures

Hazard Lamp Switch: Repair procedures

Other Information:

Categories