Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the luggage room lamp (B) when prying the hole (A) with a flat-up screwdriver. |
3. |
Remove the luggage room lamp bulb in case of necessity. |
Installation |
1. |
Replace the lamp bulb. |
2. |
Install the luggage room lamp assembly after connecting the lamp connector. |
Power Mosfet: Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
Specification
...
Trailer brakes
If your trailer is equipped with a braking system, make sure it conforms to your
state’s regulations and that it is properly installed and operating correctly.
If your trailer weight exceeds the ma ...