Kia Sportage: Description and Operation - Back View Camera System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Description and Operation

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Back View Camera System / Description and Operation

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or the Navigation unit while backing-up.
   
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can''t see through the camera.
Schematic Diagrams
Circuit Diagram ...

Repair procedures
Removal 1. Remove the tailgate trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove the tailgate garnish (A) after disconnecting the connector ...

Other Information:

Input Speed Sensor: Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (R ...

Rear Lower Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Categories


Copyright © www.kispmanual.com 2014-2024