Removal |
1. |
Remove the tailgate trim in the trunk after removing the screws and clips.
(Refer to the BD group - "Tailgate") |
2. |
Remove the tailgate garnish (A) after disconnecting the connector and removing the bolts. |
3. |
Remove the back view camera (A) after loosening the screws (2EA). |
Installation |
1. |
Install the back view camera. |
2. |
Install the tailgate garnish and trim. |
Power Seat Control Switch: Repair procedures
Inspection
1.
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
Remo ...
Intake Actuator: Description and Operation
Description
1.
The intake actuator is located at the blower unit.
2.
It regulates the intake door by signal from control unit.
3.
Pressing the intake selection switch will shift between re ...