Kia Sportage: Blower Resistor: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor: Repair procedures
| Inspection |
| 1. |
Measure terminal-to-terminal resistance of the blower resistor. |
| 2. |
measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
|
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Disconnect the blower resistor connector (A) and then remove the blower resistor (B) after loosening the mounting screws.
|
| 3. |
Installation is the reverse order of removal. |
Power Mosfet: Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
Specification
...
Climate Control Air Filter: Description and Operation
Description
This has particle filter which eliminates foreign materials
and odor. The particle filter includes odor filter as well as
conventional dust filter to ensure comfortable interior en ...
Other Information:
Rear Seat: Components and Components Location
Components
1. Headrest2. Headrest guide3. Tether anchor garnish4. Upper bezel5. Rear seat back pad6. Latch cover7. Rear seat back cover8. Armrest board9. Rear armrest10. Rear seat back frame11.Re ...
Seat belt warning
As a reminder to the driver, the seat belt warning light will blink for approximately
6 seconds each time you turn the ignition switch ON, regardless of belt fastening.
If the driver's seat b ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026