Kia Sportage: Heater & A/C Control Unit(Full Automatic): Components and Components Location
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Heating,Ventilation, Air Conditioning / Controller / Heater & A/C Control Unit(Full Automatic): Components and Components Location
| Component |
Connector Pin Function
| Connector | Pin NO | Function | Connector | Pin NO | Function |
| Connector(A) | 1 | Battery | Connector(B) | 1 | CAN (LOW) |
| 2 | Tail Lamp (ILL+) | 2 | CAN (HIGH) | ||
| 3 | IG2 | 3 | Intake Actuator (F/B) | ||
| 4 | DR Temp Actuator (COOL) | 4 | Mode Actuator (F/B) | ||
| 5 | DR Temp Actuator (WARM) | 5 | PS Temp Actuator (F/B) | ||
| 6 | Detent | 6 | DR Temp Actuator (F/B) | ||
| 7 | Mode Actuator (VENT) | 7 | Diagnosis (Cluster Ion) | ||
| 8 | Mode Actuator (DEF) | 8 | V Ref (+5V) | ||
| 9 | - | 9 | - | ||
| 10 | - | 10 | - | ||
| 11 | - | 11 | ECV IN | ||
| 12 | Rheostat (ILL-) | 12 | GND | ||
| 13 | GND | 13 | HI- Scan(L-line) | ||
| 14 | IG1 | 14 | Evaporator Sensor | ||
| 15 | Ion Signal | 15 | Ambient Sensor | ||
| 16 | Intake Actuator (FRE) | 16 | - | ||
| 17 | Intake Actuator (REC) | 17 | LH Photo (-) | ||
| 18 | Clean Signal | 18 | RH Photo (-) | ||
| 19 | Blower Motor (+) | 19 | - | ||
| 20 | PS Temp Actuator (COOL) | 20 | - | ||
| 21 | PS Temp Actuator (WARM) | 21 | - | ||
| 22 | Power Mosfet (GATE) | 22 | ECV Out | ||
| 23 | Power Mosfet (DRAIN) | | |||
| 24 | HTD(Rear Def Ind.) | ||||
| 25 | Rear Def S/W (Low) | ||||
| 26 | Sensor GND | ||||
Heater & A/C Control Unit(Manual): Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using the screwdriver, remove the cluster facia panel (A).
3.
Using the screwdriver, remove the crash pad garnish (A).
4. ...
Heater & A/C Control Unit(Full Automatic): Repair procedures
Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel flickers three times every 0.5
second, the corresponding fault code flickers on the setu ...
Other Information:
Heating
1.Set the mode to the position.
2.Set the air intake control to the outside (fresh) air position.
3.Set the temperature control to the desired position.
4.Set the fan speed control to the desired ...
Heater & A/C Control Unit(Manual): Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using the screwdriver, remove the cluster facia panel (A).
3.
Using the screwdriver, remove the crash pad garnish (A).
4. ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright www.kispmanual.com 2014-2026