The light will turn on and off as below if the switch is pressed. The light will turn off if the button is pressed again.
• Push the lens to turn the map lamp on or off. This light produces a spot beam for convenient use as a map lamp at night or as a personal lamp for the driver and the front passenger.
• DOOR
The light comes on when any door is opened or the ignition switch is turned OFF. (if equipped)
The light goes out gradually after approximately 30 seconds if the door is closed or the ignition switch is turned OFF.
However, if all doors are locked or the ignition switch is turned ON, the light will turn off immediately.
Ambient Sensor: Description and Operation
Description
1.
The ambient temperature sensor is located at the front of the
condenser and detects ambient air temperature. It is a negative type
thermistor; resistance will increase with lowe ...
Purge Control Solenoid Valve (PCSV): Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the speci ...