Kia Sportage: Cruise Control Switch: Repair procedures - Cruise Control System - Engine Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Cruise Control Switch: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch: Repair procedures

Removal and Installation
1.
Disconnect the battery (-) terminal.

Tightening torque:
Without battery sensor :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
With battery sensor :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)

2.
Remove the air-bag module from the steering wheel. ( Refer to RT group)
3.
Remove the steering wheel. (Refer to ST group)
4.
Remove the cruise control switch (A) after unfastening the 2 screws and disconnecting the switch connector.

5.
Installation is reverse order of removal.
Inspection
Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.

2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance
CANCEL
6 - 7
0? ± 5%
SET/–
6 - 7
220? ± 5%
RES/+
6 - 7
910? ± 5%
ON/OFF
7 - 8
3900? ± 5%

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
Terminal
Voltage
CANCEL
6 - 7
0.0 ± 0.22V
SET/–
6 - 7
1.5 ± 0.22V
RES/+
6 - 7
3.0 ± 0.22V
ON/OFF
7 - 8
-

3.
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace the switch and measure the voltage again.
4.
If resistance is OK but, measuring voltage is not within specification, inspect the wiring harness and connectors between the switch and the ECM.
Cruise Control Switch: Schematic Diagrams
Circuit Diagram ...

Emission Control System
...

Other Information:

Rear Door: Components and Components Location
Components 1. Rear door trim2. Rear door inside handle cap3. Rear door belt inside weatherstrip4. Rear door trim seal5. Rear door module6. Rear door panel7. Rear door belt weatherstrip8. Rear doo ...

Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to reach this equipment. (1) Jack handle (2) Jack (3) Wheel lug nut wrench Jacki ...

Categories

Copyright www.kispmanual.com 2014-2026