Kia Sportage: Fuel Tank Air Filter: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter: Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Lift the vehicle with a jack. |
| 3. |
Disconnect the canister close valve connector (A). |
| 4. |
Disconnect the ventilation hose (B) and vapor hose (C).
|
| 5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the installation nut (B).
|
| 6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure.
|
| 7. |
Install a new fuel tank air filter in accordance with the reverse order.
|
| Installation |
Installation is the reverse of removal.
Fuel tank air filter bracket installation nut: 4.8 ~ 5.2 N.m (0.5 ~ 0.53 kgf.m, 3.54 ~ 3.84 lb-ft) |
Fuel Filler Cap: Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel
filler. After the gasket on the fuel filler cap and t ...
Other Information:
Rear Wiper Motor: Repair procedures
Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that ...
Checking the coolant level
WARNING - Removing radiator cap
Never attempt to remove the radiator cap while the engine is operating or
hot. Doing so might lead to cooling system and engine damage.
Also, hot coolant or s ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2025