Kia Optima Manuals

Kia Sportage: Manifold Absolute Pressure Sensor (MAPS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Manifold Absolute Pressure Sensor (MAPS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS): Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the installation bolts (B), and then remove the sensor from the surge tank.
[MAPS #1]

[MAPS #2]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Manifold absolute pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Manifold Absolute Pressure Sensor (MAPS): Schematic Diagrams
Circuit Diagram ...

Intake Air Temperature Sensor (IATS): Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t ...

Other Information:

Description and Operation
Operation Function Of Safety Power Window When all door (Front, Rear) power window auto-up switch is operated, safety function is activated. 1. Safety function condition When detect the force o ...

Canister Close Valve (CCV): Schematic Diagrams
Circuit Diagram ...

Categories

Copyright www.kispmanual.com 2014-2026