Kia Optima Manuals

Kia Sportage: Knock Sensor (KS): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Knock Sensor (KS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS): Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the knock sensor connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
Knock Sensor (KS): Schematic Diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S): Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

Other Information:

Alignment: Repair procedures
Front Wheel Alignment     When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle o ...

Rear Door: Repair procedures
Replacement Door Trim Replacement     • Take care not to scratch the door trim and other parts. • Put on gloves to protect your hands. 1. Using ...

Categories

Copyright www.kispmanual.com 2014-2026