Kia Optima Manuals

Kia Sportage: Heated Oxygen Sensor (HO2S): Repair procedures - Engine Control System - Engine Control / Fuel System - Kia Sportage SL Service & Repair ManualKia Sportage: Heated Oxygen Sensor (HO2S): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S): Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
4.
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
[Bank 1 / Sensor 1]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the connector (A), and then remove the sensor (B).
   
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 2]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the console side cover (A).

3.
Disconnect the connector (A), and then remove the sensor (B).
   
Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
   
•
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
•
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Installation is reverse of removal.
Heated oxygen sensor installation [Bank 1/Sensor1]:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated oxygen sensor installation[Bank 1/Sensor2]:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
Heated Oxygen Sensor (HO2S): Schematic Diagrams
Circuit Diagram ...

Rail Pressure Sensor (RPS): Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in ...

Other Information:

Driving at night
Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may ...

Rear camera display
The Rear camera display will activate when the back up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that shows beh ...

Categories

Copyright www.kispmanual.com 2014-2026