Circuit Diagram |
4WD ECU Connector |
Pin | Function |
1 | Oil pressure motor A |
2 | Oil pressure motor B |
3 | Lock mode switch |
4 | - |
5 | Input sensor signal(+) |
6 | - |
7 | CAN communication line (High) |
8 | CAN communication line (Low) |
9 | - |
10 | - |
11 | - |
12 | IG power |
13 | Ground |
14 | Battery power |
15 | Input sensor signal(-) |
16 | Pressure sensor(Input) |
17 | - |
18 | - |
4WD ECU Circuit Diagram |
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...
Rear Shock Absorber: Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bol ...