Kia Sportage: Rear Driveshaft Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Rear Driveshaft Assembly

Rear Hub - Carrier: Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.3 ~ 1 ...

Rear Driveshaft: Components and Components Location

Component location 1. Coupling2. Sub frame3. Assist arm4. Lower arm5. Upper arm6. Trailing arm7. Coil spring8. Shock absorber9. Stabilizer10. Drive shaft11. Differential carrier assembly Compone ...

Other Information:

Master Cylinder: Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the battery terminal and then remove the battery. 3. Disconnect the ECM connector and the E ...

Digital clock
Whenever the battery terminals or related fuses are disconnected, you must reset the time. For details, refer to the audio in the end of this section. WARNING - Clock those may damage the ho ...