Kia Sportage: Rear Driveshaft: Components and Components Location

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Rear Driveshaft Assembly / Rear Driveshaft: Components and Components Location

Component location

1. Coupling
2. Sub frame
3. Assist arm
4. Lower arm
5. Upper arm

6. Trailing arm
7. Coil spring
8. Shock absorber
9. Stabilizer
10. Drive shaft
11. Differential carrier assembly

Components

1. Lock nut
2. Tone wheel
3. BJ assembly
4. BJ boot

5. BJ boot big part band
6. Boot small part band
7. Shaft
8. TJ boot big part band

9. TJ boot
10. Snap ring
11. TJ assembly
12. Circlip

Rear Driveshaft Assembly

...

Rear Driveshaft: Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.3 ~ 1 ...

Other Information:

Rail Pressure Sensor (RPS): Troubleshooting
Signal Waveform ...

Rear Stabilizer Bar: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bol ...

Kia Sportage: Rear Driveshaft: Components and Components Location

Rear Driveshaft Assembly

Rear Driveshaft: Repair procedures

Other Information:

Categories