Kia Sportage: Propeller Shaft Assembly

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Driveshaft and axle / Propeller Shaft Assembly

Rear Driveshaft: Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque : 88.3 ~ 1 ...

Propeller Shaft: Components and Components Location

Components 1. Front propeller shaft2. Center bearing bracket3. Rear propeller shaft ...

Other Information:

Blower Resistor: Repair procedures
Inspection 1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After removing the resi ...

Wheel: Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     When using an impact gun, fi ...