Kia Optima Manuals

Kia Sportage: Rear Upper Arm: Repair procedures - Rear Suspension System - Suspension System - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Upper Arm: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Suspension System / Rear Suspension System / Rear Upper Arm: Repair procedures

Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel & tire (A).
2.
Loosen the bolt & nut and then remove the rear upper arm (A) with the rear axle.
Tightening torque :
2WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
4WD
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)
[2WD]

[4WD]

3.
Loosen the bolt & nut and then remove the rear upper arm (A) with the sub frame.
Tightening torque :
2WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
4WD
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)
[2WD]

[4WD]

4.
Installation is the reverse of removal.
   
Install the rear upper arm so that the letter ''R'' can face the rear of vehicle.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear upper arm or damage and deformation.
3.
Check for all bolts and nut.
Rear Shock Absorber: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Rear Lower Arm: Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage to the hub bol ...

Other Information:

Ignition key interlock system
The ignition key cannot be removed unless the shift lever is in the P (Park) position. Even if the ignition switch is in the LOCK position, the key also cannot be removed. If your vehicle is equi ...

Immobilizer Control Unit: Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") 3. Remove the steering column assembly. (Refer to the ...

Categories


Copyright © www.kispmanual.com 2014-2025