Kia Sportage: Rear Wheel Speed Sensor: Repair procedures

Third generation SL (2010â€“2016) / Kia Sportage SL Service & Repair Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor: Repair procedures

Removal

Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.	Remove the luggage side trim the disconnect the rear wheel speed sensor connector.

3.	Installation is the reverse of removal.

Inspection

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resistor must be used as shown.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V ~ 0.84V

V_high : 1.18V ~ 1.68V

Frequency range : 1 ~ 2,500Hz

Rear Wheel Speed Sensor: Components and Components Location

Components 1. Rear wheel speed sensor connector2. Rear wheel speed sensor ...

Yaw-rate and Lateral G Sensor: Description and Operation

Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor. ...

Other Information:

Manifold Absolute Pressure Sensor (MAPS): Specifications
Specification Pressure[kPa (kgf/cm?, psi)]Output Voltage (V)20.0 (0.20, 2.9)0.7946.7 (0.47, 6.77)1.84101.3 (1.03, 14.7)4.0 ...

Tail Gate: Repair procedures
Replacement Tail Gate Trim Replacement â€¢ When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the relate ...

Kia Sportage: Rear Wheel Speed Sensor: Repair procedures

Rear Wheel Speed Sensor: Components and Components Location

Yaw-rate and Lateral G Sensor: Description and Operation

Other Information:

Categories