Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the floor console upper cover. |
3. |
Disconnect the yaw rate & lateral & Longitudinal G sensor connector (A). |
4. |
Remove the mounting bolts (B).
|
5. |
Installation is the reverse of removal. |
Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels al ...
Rear Door: Components and Components Location
Components
1. Rear door trim2. Rear door inside handle cap3. Rear door belt inside weatherstrip4. Rear door trim seal5. Rear door module6. Rear door panel7. Rear door belt weatherstrip8. Rear doo ...